| General
Specification |
| Max.
Input Current |
ACE-723A/723B: 5A/115VAC or
230VAC |
Hi-Pot
Isolation (ACE-723A/723B/716A) |
4300VDC, input to output for one
minute
2200VDC, input to ground for one minute
500VDC, output to ground for one minute |
| Inrush
Current: |
will not exceed 15A/115VAC or
30A/230VAC (ACE-723A/723B/716A) |
Leakage
Current: |
about 0.9mA, Line to Ground |
| Ripple
and Noise: |
The peak to peak ripple and noise
for each output is less than 100mV at rated load. Measuring is done by 15MHz band width
limited oscilloscope and terminated wach output with a 0.47uF capacitor |
Hold-up
Time: |
Hold-up Time is longer than 20ms
by measuring from the last AC line charging pulse to the point that +5V drop down to
+4.75V |
| Line
Regulation: |
The line regulation for each
output is less than +/-1% while measuring at rated load and +/-10% of input voltage
changing. |
Input
Protection: |
- ACE-723A/723B/716A: Input line fuse provided.
Internally loacted
- ACE-723T/723C/716T/716C: Protection against wrong polarity if -48/24V
volts inverse by mistake
|
| Load
Regulation: |
The output voltage load
regulation is less than the values in the following table by changing each output load
+/-40% from 60% rated load, and keep all other outputs at 60% rated load.
Output# +5: +/-1% +12V: +/-4% +24V: +/-4%
-5V: +/-1% -12V: +/-1% |
Output
protection: |
The built-in over voltage
protection circuit will shut down the outputs to prevent damaging external circuits.
The trip point of crowbar circuit is around 5.9V to 7.0V. The power supply
will go into latch off against short circuit or over conditions, and will have to OFF and
ON the input line to restart the power supply. |
| Thermal
Protection: |
Built-in 110°C +/-5% in HS1. |
Efficiency: |
The efficiencfy is 75% typical by
measuring at nominal line and rated load. |
| Safety |
Designed with cover to meet the
following standards
UL 478, 1012, 1950 D3
TUV EN60 950
CSA 22.2 No.234 |
EMI: |
Designed with cover to meet the
following standards
FCC docket 20780 curve "A"
EN 50081-2 : CISPR22 "A" |
| EMS: |
Designed with cover to meet the
following standardsEN 50082-2
IEC 801-2, 8KV(Air Discharge) criteria B
IEC 801-3 10V/M criteria A
IEC 801-4 2KV criteria B
IEC 801-5 2KV criteria B |
Connectors: |
AC Input: TB1, terminal blocks
DC Outlet: TB2, terminal blocks
12V fan connector: TB3, Molex 5045-2 or equivalent
Power LED connector: TB4, Molex 5045-2 or equivalent |
| Operating
Temperature: |
-20°C to 70°C |
Storage
Temperature: |
-30°C to 85°C |
| Altitude: |
0 to 10,000 feet |
Vibratiion: |
10-55Hz at 2G 3min. period,
30min. alone, X, Y, Z axis |
| Shock: |
10G for 20ms once on each X, Y,
and Z axis. |
|
|
